← All reports
Benchmarks8 min read

Multifamily Utility Spend Benchmarks: What Public Data Shows

Apartment households in 5+ unit buildings spent $1,107 on energy in 2020, half the house average. Electricity prices have risen 42 percent since then.

No public dataset reports what apartment owners pay for utilities per unit. Four federal sources cover parts of the picture: household energy spending by building type, price changes by utility, and median energy and water intensity for multifamily buildings. This report sets out what each one measures, the numbers it supports, and where it stops.

Key findings

What does each dataset measure?

DatasetWhat it measuresLatest yearMain limit for operators
EIA RECSEnergy use and spending of occupied primary homes, by housing type2020Household bills only. No water, no trash, no common-area or vacant-unit cost
EIA CBECSEnergy use of commercial buildings2018Excludes buildings that are mostly residential, so apartments are out of scope
BLS CPIChange in prices paid by urban consumersOctober 2026An index of price change. It gives no dollar level and tracks residential rates
EIA Electric Power MonthlyAverage retail electricity price by customer sectorAugust 2026National averages. Your tariff will differ
EPA ENERGY STAR reference tablesMedian energy and water intensity by property typePublished 2023 and 2024Multifamily medians come from a 2012 survey

Two points follow from this table. RECS is the only source with dollar figures by building type, and it is a household survey. CBECS, which most commercial energy benchmarks rely on, does not cover apartment buildings at all. EIA defines a commercial building as one where at least half the floorspace is used for a purpose that is not residential, industrial or agricultural.

How much do apartment households spend on energy?

RECS 2020 surveyed occupied primary housing units in all 50 states and the District of Columbia. Vacant units, seasonal units and second homes are excluded. The figures below are site energy expenditures for electricity, natural gas, propane and fuel oil.

Housing type (2020)Households (million)Energy spend per householdPer household memberPer square foot
Single-family detached77.07$2,205$836$0.97
Single-family attached7.45$1,653$681$1.02
Apartments, 2 to 4 units9.34$1,406$585$1.44
Apartments, 5 or more units22.84$1,107$589$1.22
Mobile homes6.83$1,773$731$1.46
All homes123.53$1,884$768$1.04

Source: EIA RECS 2020, Table CE1.1.

A household in a large apartment building spends about half of what a detached-house household spends. The unit is smaller and shares walls, so it needs less heating and cooling. Per square foot the apartment costs 26 percent more, because the same appliances, water heating and lighting sit in a smaller space.

Renters in apartments of any size averaged $1,151 in 2020, and renters in single-family homes averaged $1,869.

Which fuels drive the bill?

Apartments, 5 or more units (2020)Total spend (billion)Average per household using the fuel
Electricity$20.16$883
Natural gas$4.58$388
Propane$0.14$271
Fuel oil or kerosene$0.40$635
All fuels$25.28$1,107

Source: EIA RECS 2020, Table CE2.6.

Electricity is the benchmark that matters most for apartment buildings. Gas matters where the building has central heat or central hot water, and in those buildings the owner usually holds the account.

Who pays the bill?

RECS also asks how energy bills are paid. In 2020, 112.70 million households paid all of their own energy bills. Another 6.32 million had some energy included in rent or a condo fee, and 4.34 million had all of it included. Together that is 10.66 million households, or about 9 percent, where an owner or association carried some or all of the energy cost. RECS does not publish this split for 5+ unit buildings in Table CE1.1, so the apartment-only share is not available from that table.

How much have prices changed since 2020?

RECS dollars are 2020 dollars. The BLS Consumer Price Index shows how far prices have moved since then.

CPI category (US city average)12 months to September 2026September 2020 to September 2026
Electricity+4.4%+41.9%
Utility (piped) gas service+5.0%+53.7%
Water, sewer and trash collection+4.8%+31.9%
Rent of primary residence+2.8%+31.3%

Source: BLS CPI series for electricity, utility gas, water, sewer and trash and rent, not seasonally adjusted. Changes are calculated from the published index levels.

September is used because BLS did not publish an October 2025 index after the 2025 lapse in appropriations. A 12-month change to October 2026 cannot be calculated.

Electricity and gas prices have outrun rent by a wide margin over six years. Water, sewer and trash have moved almost exactly with rent. For an owner who pays utilities and collects rent, that gap is margin lost unless costs are recovered or consumption falls.

EIA's own price series tells the same story in cents. The average US residential electricity price was 13.15 cents per kilowatt-hour in 2020 and 17.23 cents in 2025, a rise of 31 percent. The preliminary figure for August 2026 was 18.16 cents. The commercial average, which is closer to what many master-metered and common-area accounts pay, went from 10.59 cents in 2020 to 13.37 cents in 2025, a rise of 26 percent. Source: EIA Electric Power Monthly, Table 5.3.

An illustration, not a measurement

If a 2020 apartment household used the same amount of electricity in 2025, the 31 percent rise in the average residential price would take an $883 bill to about $1,157. Actual 2025 spending depends on weather, occupancy and local rates, and no federal survey has measured it yet. The next RECS will.

What do building-level benchmarks show?

EPA's ENERGY STAR Portfolio Manager is the tool most owners use to benchmark whole buildings. EPA publishes national medians by property type.

Multifamily housing benchmarkValueUnderlying data
Median source energy use intensity118.1 kBtu per square footFannie Mae industry survey, table dated August 2024
Median site energy use intensity59.6 kBtu per square footSame
Median water use intensity45.15 gallons per square foot per year2012 Fannie Mae Energy and Water Market Research Survey, 258 properties
Water use, 25th to 75th percentile31.71 to 65.56 gallons per square foot per yearSame
Water use, 5th to 95th percentile16.76 to 126.14 gallons per square foot per yearSame
Median water use per unit43,600 gallons per unit per yearSame

Sources: EPA, U.S. Energy Use Intensity by Property Type and EPA, U.S. Water Use Intensity by Property Type.

Unlike RECS, these figures cover the whole building, including common areas. They are intensities, so they carry no price.

The water range is the useful part. A building at the 75th percentile uses about twice the water per square foot of a building at the 25th percentile. EPA cautions that its water reference data is entered by users, is not verified, and should not be read as statistically representative. For most property types the data is from 2019. For multifamily it is from the 2012 Fannie Mae survey.

What is missing from public data?

Four gaps matter for anyone building a budget from these sources.

  1. Owner-paid cost per unit. No federal dataset reports common-area electricity, central plant gas, vacant-unit cost or house-meter water for apartment properties.
  2. Water and sewer dollars. RECS covers energy only. CPI gives a rate of change for water and sewer and no dollar level.
  3. Trash. There is no public per-unit benchmark. CPI tracks the price change only.
  4. Recent years. The newest dollar figures by building type are from 2020. Everything after that is a price index applied to an old base.

We could not retrieve a multifamily issue of EPA's DataTrends series, so this report relies on EPA's two technical reference tables.

How should an operator use these numbers?

Use them to check direction and order of magnitude. Use your own invoices for the level.

Method and sources

All figures were read from the source tables in November 2026. Percentages in the CPI table are calculated from BLS index levels. Shares of RECS totals are calculated from the published totals. Nothing in this report comes from AirBills customer data.

How AirBills helps

Public data stops at the household meter and at 2020. AirBills captures every utility invoice across a multifamily portfolio, flags spikes and anomalies as bills arrive, and reports spend by property and utility type. That gives you a current, owner-side benchmark built from your own bills.

Billing That Runs Itself

Automate tenant billing, cut disputes, and reclaim hours every week.

Book a Demo